All articles

Pedal Assist System (PAS) does not work:Updated 7 months ago

Make sure that the PAS sensor cable is connected to the orange connector on the controller and the gap between the sensor and the magnetic rotor is less than half an Inch.
Try pedaling backwards to see if it engages the hub motor or not.
The rotor might be installed in the wrong direction.
If you have an LCD display (SW900 or S830), make sure that you have the following parameters set on the settings panel:
P07 - 46 for Direct Drive (1200w or higher) motors and 100 for Geared (500w) motors.
P08 - 99
P09 - 0
P10 - 2
P11 - 1
 P12 - 2
P13 - 8 (as default), but you can try 12 in case it does not work. 

Was this article helpful?
Yes
No