How do I install PAS?Updated 6 months ago

Pedal assist system uses a magnetic sensor and a magnetic ring to sense how fast the rider is pedaling. This information is then processed by the controller and depending on the chosen assist level, the motor will apply additional power to the wheel. Installation starts by taking the left pedal off the hub. You should now see the lock ring holding the pedal hub inside the bicycle frame. Take this ring off, install the sensor then tighten the ring back on the hub and on the sensor ring. Now a magnetic ring is pushed on the hub paying attention to the arrows. Put the pedal back and tighten with a ratchet to specs. PAS wire must go right!